I have a problem on Gnumeric. I downloaded modules32-1.tar : 32bit (129M) which was written in the neko's thread http://forum.porteus.org/viewtopic.php? ... ric#p21663 and put gnumeric.xzm into /porteus/modules. It seemed it works fine, however, as I select one cell of sheet and choose Format 1-Cell, it freezes.
Does anyone know how to fix this problem?
When I run Gnumeric from Terminal, I get this message:
Code: Select all
guest@porteus:~$ gnumeric GConf Error: Configuration server couldn't be contacted: D-BUS error: Message did not receive a reply (timeout by message bus)