Hi,
as I can not find it on the PPM and as I have a Zendstudio version that work on Slax 6.1.2 (maybe 32 bits).
How could I convert it to a Porteus 1.2 64 bits ?
Sincerely thanks and have a nice day,
Miguipda ;-)
Zendstudio
If you are looking for a specific 64-bit package and you can't find it in any of the 64-bit repos, please post a request for it here
miguipda
Hamza
Re: Zendstudio
Post#3 by miguipda » 08 Jul 2012, 12:37
Hi,
as explained I have an existing version I used in SLAX 6.1.2 (.lzm) how could I extractt it and get it work in the Porteus 1.2 64 bits ?
Sincerely thanks and have a nice day,
Miguipda ;-)
as explained I have an existing version I used in SLAX 6.1.2 (.lzm) how could I extractt it and get it work in the Porteus 1.2 64 bits ?
Sincerely thanks and have a nice day,
Miguipda ;-)
miguipda
Re: Zendstudio
Post#4 by Hamza » 08 Jul 2012, 12:59
Under Slax, lzm2dir. Save the output to a linux filesystem to save symlink. After done this, Go on Porteus and do dir2xzm and activate the module.
NjVFQzY2Rg==
Hamza
Re: Zendstudio
Post#5 by miguipda » 08 Jul 2012, 13:31
Hi,
Ok when I will be able to add the .cfg parameter to let use the existing SLAX (on partition 1) I wil try those command lines. As you know now I have some teamviewer and skype problems.
Sincerely thanks for your assistance.
Have a nice day, ;-)
Miguipda ;-)
Ok when I will be able to add the .cfg parameter to let use the existing SLAX (on partition 1) I wil try those command lines. As you know now I have some teamviewer and skype problems.
Sincerely thanks for your assistance.
Have a nice day, ;-)
Miguipda ;-)
miguipda
