Page 1 of 1
Touch pad problems
Posted: 04 Mar 2016, 20:36
by Wnderer
The buttons and scroll bar on my touch pad don't work. I have been unable to figure out tapping settings that will work consistently. I tried to run synclient and I get the error 'Unable to start Xwindows'. What can I do to get my touch pad to work?
Re: Touch pad problems
Posted: 04 Mar 2016, 22:54
by francois
Please provide output of lspci in command line.
Thanks.
Re: Touch pad problems
Posted: 05 Mar 2016, 15:10
by Wnderer
lspci returns
00:00:0 Host bridge: Advanced Micro Devices, Inc. [AMD/ATI] RS100 Host Bridge (rev13)
00:01.0 PCI bridge: Advanced Micro Devices, Inc. [AMD/ATI] RS100 AGP (rev 01)
00:02.0 USB controller: ULi Electronics Inc. USB 1.1 Controller (rev 03)
00:06.0 Multimedia audio controller: ULi Electronics Inc. M5451 PCI AC-Link Controller Audio Device (rev 02)
00:07.0 ISA bridge: ULi Electronics Inc. M1533/M1535/M1543 PCI to ISA Bridge [Aladin IV/V/V+]
00:08.0 Modem: ULi Electronics Inc. M5457 AC'97 Modem Controller
00:0a.0 CardBus bridge: 02 Micro, Inc. 0Z601/6912/711E0 CardBus/SmartCardBus Controller
00:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21 IEEE-1394a-2000 Controller (PHY/Link)
00:10.0 IDE interface: ULi Electronics Inc. M5229 IDE (rev c4)
00:11.0 Bridge: ULi Electronics Inc. M7101 Power Management Controller {PMU]
00:12.0 Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
01:05.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] RS100 [Radeon IGP 30M]