I am aiming for a porteus hdd install on a windows 10 uefi intallation.
Yet I have reformated the toshiba z930 to make some place for a poteus partitions by using a debian live disk. The installation will not boot into linux.
I do not have the courage to follow the following procedure:
https://www.lifewire.com/dual-boot-wind ... ie-2202088
Is there a simpler way to do this. Here is my partition setup:
Code: Select all
user@debian:~$user@debian:~$ sudo fdisk -l
Disk /dev/sda: 238.5 GiB, 256060514304 bytes, 500118192 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: gpt
Disk identifier: A982906B-E35A-11E2-940E-B86B23A08C17
Device Start End Sectors Size Type
/dev/sda1 2048 1023999 1021952 499M Windows recovery environment
/dev/sda2 1024000 1228799 204800 100M EFI System
/dev/sda3 1228800 1261567 32768 16M Microsoft reserved
/dev/sda4 1261568 250060799 248799232 118.7G Microsoft basic data
/dev/sda5 250060800 250548223 487424 238M EFI System
/dev/sda6 250548224 330235903 79687680 38G Linux filesystem
/dev/sda7 330235904 437657599 107421696 51.2G Linux filesystem
/dev/sda8 437657600 496250879 58593280 28G Linux filesystem
/dev/sda9 496250880 500117503 3866624 1.9G Linux swap