Hey,
I was wondering, is it possible to set a different MTU in the network settings for the kiosk client?
Thanks
-
[Solved] Possibilies of Network Setting in Client
Forum rules
Porteus Kiosk section of the forum is unmaintained now. Its kept in a 'read only' mode for archival purposes.
Please use the kiosk contact page for directing your queries: https://porteus-kiosk.org/contact.html
Porteus Kiosk section of the forum is unmaintained now. Its kept in a 'read only' mode for archival purposes.
Please use the kiosk contact page for directing your queries: https://porteus-kiosk.org/contact.html
[Solved] Possibilies of Network Setting in Client
Last edited by NewinTown on 08 Aug 2023, 13:26, edited 1 time in total.
- fanthom
- Moderator Team
- Posts: 5667
- Joined: 28 Dec 2010, 02:42
- Distribution: Porteus Kiosk
- Location: Poland
- Contact:
Possibilies of Network Setting in Client
You can do this using 'run_command=' parameter:
https://porteus-kiosk.org/parameters.html#run_command
sample:
Thanks
https://porteus-kiosk.org/parameters.html#run_command
sample:
Code: Select all
run_command=ifconfig eth0 mtu 1000
Please add [Solved] to your thread title if the solution was found.
Possibilies of Network Setting in Client
Hi,
thanks for your quick reply.
So I just need to add the parameter in the kiosk_config.txt?
The network config will always asign eth0 to the network card?
thanks
thanks for your quick reply.
So I just need to add the parameter in the kiosk_config.txt?
The network config will always asign eth0 to the network card?
thanks
- fanthom
- Moderator Team
- Posts: 5667
- Joined: 28 Dec 2010, 02:42
- Distribution: Porteus Kiosk
- Location: Poland
- Contact:
Possibilies of Network Setting in Client
1) Yes
2) If you have 2 NICs then you can repeat this command on eth1 (read parameter description how to run 2 commands).
2) If you have 2 NICs then you can repeat this command on eth1 (read parameter description how to run 2 commands).
Please add [Solved] to your thread title if the solution was found.
Possibilies of Network Setting in Client
Thanks for your help!
[Solved]
[Solved]