CopyToRam
Posted: 22 Jun 2014, 04:55
Hi,
I am quite new to porteus relatively. Been using mostly the porteus desktop version all via straight ISO boot and copytoram.
I just like to know if copytoram is also supported for the KIOSK version. I tried the following without success (I am using grub 1.98) :
menuentry "Porteus KIOSK "
{
set uuid_partition=7507-8BE0
search --no-floppy --fs-uuid $uuid_partition --set=root
loopback loop ($root)/PorteusKiosk31_i486.iso
linux (loop)/boot/vmlinuz from=/PorteusKiosk31_i486.iso iso-scan/filename=/PorteusKiosk31_i486.iso copy2ram
initrd (loop)/boot/initrd.xz http_server=
}
Wheen booting, the system displays:
Device not ready yet? Delay 20 seconds.....
It then counts down to 0 and then displays:
3.12.20-Porteus-Kiosk
net.ifnames=0 BOOT_IMAGE=(loop)/boot/vmlinuz from=/PorteusKiosk31_i486.iso
Then kicks into # command line.
thanks in advance
I am quite new to porteus relatively. Been using mostly the porteus desktop version all via straight ISO boot and copytoram.
I just like to know if copytoram is also supported for the KIOSK version. I tried the following without success (I am using grub 1.98) :
menuentry "Porteus KIOSK "
{
set uuid_partition=7507-8BE0
search --no-floppy --fs-uuid $uuid_partition --set=root
loopback loop ($root)/PorteusKiosk31_i486.iso
linux (loop)/boot/vmlinuz from=/PorteusKiosk31_i486.iso iso-scan/filename=/PorteusKiosk31_i486.iso copy2ram
initrd (loop)/boot/initrd.xz http_server=
}
Wheen booting, the system displays:
Device not ready yet? Delay 20 seconds.....
It then counts down to 0 and then displays:
3.12.20-Porteus-Kiosk
net.ifnames=0 BOOT_IMAGE=(loop)/boot/vmlinuz from=/PorteusKiosk31_i486.iso
Then kicks into # command line.
thanks in advance