1) I knew that Broadcom were not easy. drivers. Under slax remix here was my solution:
http://slax.speedymirror.com/forum.php? ... ntID=70793
" Wifi is finally working for me. I knew that linux sta for bcm was on the distribution. I finally understood that to use the bcm43xx (for me 4328), all I had to do was to blaclist ssb and b43 in /etc/modprobe.d/blacklist.conf, as proposed in:
https://wiki.archlinux.org/index.php/Broadcom_BCM43XX"
2) Working on wired network since I got Porteus v 1.0. It seems that blacklisting ssb and b43 at least will provide eth1:
Code: Select all
bash-4.1# ifconfig
eth0 Link encap:Ethernet HWaddr 00:1d:72:44:d2:fe
inet addr:192.168.1.11 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::21d:72ff:fe44:d2fe/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:10193 errors:0 dropped:6 overruns:0 frame:0
TX packets:9348 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7824744 (7.4 MiB) TX bytes:1743721 (1.6 MiB)
Interrupt:42 Base address:0x2000
eth1 Link encap:Ethernet HWaddr 00:1a:73:eb:70:93
inet6 addr: fe80::21a:73ff:feeb:7093/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:21
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:10 errors:0 dropped:0 overruns:0 frame:0
TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:500 (500.0 B) TX bytes:500 (500.0 B)
http://pastebin.com/utTjVMFu
Any suggestion?