Page 1 of 1


Posted: 18 May 2013, 17:49
by ralcocer
When I try to setup my printer, I have to start the rc.cups manualy. Is this normal with version2.0?

Re: printer

Posted: 19 May 2013, 14:00
by brokenman
Fanthom pointed us over to this post and asked to check that rc.cups is executable by default in 32bit v2.0 which i can confirm.

Please give output (directly after boot) from:

Code: Select all

ls -l /etc/rc.d/rc.cups
During boot all executables in /etc/rc.d should be started. Do you have any extra modules that may be overwriting the existing default rc.cups file?

Re: printer

Posted: 19 May 2013, 20:39
by ralcocer
rc.cups is executable , it will not start , gives lp* errors if I start it manually /home/guest# /etc/rc.d/rc.cups start
cups: started scheduler. it will run. It did the same thing from .iso.

Re: printer

Posted: 20 May 2013, 13:52
by ralcocer
Solved, the problem was the Brother cupswrapper script. just forgot I put it in the rootcopy.