Page 1 of 1
Porteus install script on Porteus-2.0 RC1
Posted: 31 Dec 2012, 14:09
by Hamza
Hi,
When I would to copy my Porteus into a partition formatted with ext4. I'm getting this issue.
Screenshot
HOW TO REPRODUCE
- Boot into Always Fresh Mode
- Open a terminal
- Copy all your data on a fresh formatted partition
- Executes these commands:
Thanks
Re: Porteus install script on Porteus-2.0 RC1
Posted: 31 Dec 2012, 14:15
by beny
i have done two system ext4 and no trouble with the linux installer.are you shure that the media are formatted well in ext 4 and you have put the flag, boot? i use 64 bit
Re: Porteus install script on Porteus-2.0 RC1
Posted: 31 Dec 2012, 14:18
by Hamza
Yes, I'm sure. Here is a screenshot of GParted about this partition.
Screenshot
Re: Porteus install script on Porteus-2.0 RC1
Posted: 31 Dec 2012, 14:23
by beny
i use sh instead ./ and the script i don't think it is different from 32 to 64 bit.. and the name of device is right? you have put in the changes folder if any?
Re: Porteus install script on Porteus-2.0 RC1
Posted: 31 Dec 2012, 14:28
by Hamza
This works with sh, thanks. Why does this doesn't works natively just by using the selected interpreter at head of script?
Re: Porteus install script on Porteus-2.0 RC1
Posted: 31 Dec 2012, 14:29
by beny
good hamza i have used always sh to run the bash script
Re: Porteus install script on Porteus-2.0 RC1
Posted: 01 Jan 2013, 15:12
by fanthom
@Hamza
as per:
http://files.porteus.org/screen.png
i see that installer detected your partition as 'aufs'.
you must have run this script from /root or any other folder in '/' and not /mnt/sdXY/boot
will try to tweak the installer to detect destination partition despite of the folder you are currently in.
Re: Porteus install script on Porteus-2.0 RC1
Posted: 01 Jan 2013, 15:14
by Hamza
thanks!