Version 5.0.0 works fine after all, my error
Posted: 20 May 2020, 18:32
NOTE: I found that I was missing two lines in my config file that once put in place, the system worked as expected. those two lines were:
connection=wired
network_interface=eth0
I just downloaded and attempted to install the new 5.0.0 version of porteus kiosk. The installer runs and I choose to load in my config file so the kiosk will configure properly after its first boot. However, after installing, there is a plain install of the kiosk and it does not ever attempt to reach out to the remote config. Is there something I am doing wrong? the config I am importing from a file on a usb drive is (this config works in previous versions of porteus kiosk.):
kiosk_config=http://user:secret@[internalIP]:800/kiosk/config/kiosk-config.txt
browser=chrome
additional_components=08-ssh.xzm 09-x11vnc.xzm 10-printing.xzm uefi.zip
ip_address=192.168.111.3
netmask=255.255.255.248
default_gateway=192.168.111.1
dns_server=192.168.1.4 8.8.8.8
connection=wired
network_interface=eth0
I just downloaded and attempted to install the new 5.0.0 version of porteus kiosk. The installer runs and I choose to load in my config file so the kiosk will configure properly after its first boot. However, after installing, there is a plain install of the kiosk and it does not ever attempt to reach out to the remote config. Is there something I am doing wrong? the config I am importing from a file on a usb drive is (this config works in previous versions of porteus kiosk.):
kiosk_config=http://user:secret@[internalIP]:800/kiosk/config/kiosk-config.txt
browser=chrome
additional_components=08-ssh.xzm 09-x11vnc.xzm 10-printing.xzm uefi.zip
ip_address=192.168.111.3
netmask=255.255.255.248
default_gateway=192.168.111.1
dns_server=192.168.1.4 8.8.8.8