Boot loader broken after burning to USB
Forum rules
Porteus Kiosk section of the forum is unmaintained now. Its kept in a 'read only' mode for archival purposes.
Please use the kiosk contact page for directing your queries: https://porteus-kiosk.org/contact.html
Porteus Kiosk section of the forum is unmaintained now. Its kept in a 'read only' mode for archival purposes.
Please use the kiosk contact page for directing your queries: https://porteus-kiosk.org/contact.html
Boot loader broken after burning to USB
After going through the wizard and burning a kiosk 3.3 image to USB this is the result I get. Have tried two different USB drives. 3.1 works fine.
-
fanthom
- Moderator Team
- Posts: 5667
- Joined: 28 Dec 2010, 02:42
- Distribution: Porteus Kiosk
- Location: Poland
- Contact:
Re: Boot loader broken after burning to USB
never seen such behavior before ... - was the ISO modified in any way?
whats the RAM available on this PC? could you install the same ISO on virtual hard drive in VirtualBox?
thanks
whats the RAM available on this PC? could you install the same ISO on virtual hard drive in VirtualBox?
thanks
Please add [Solved] to your thread title if the solution was found.
Re: Boot loader broken after burning to USB
It's the stock ISO not modified in any way but it's not the installer that's the issue. Used both DD in Porteus and Win32DiskImager on Win 8 64 bit to dump the ISO to a USB. Runs fine on the machine (Dell e5400, 2GB or RAM). Will try another machine.
