Porteus

Thank you all very much. I found one of the application was embedded in EMBOSS, which works fine.

hi, Bogomips, thanks for your reply. I tried but it does not work. I made two modules with USM from the database slackonly : primer3 and perlprimer, for primer3, I could not find how to launch it, and Run command could not launch it either; perlprimer is listed in the panel, but nothing happens when...

Hi,

I made several modules using USM; they were activated successfully but all with error messages saying "Failed to ... panel".

I tried to RUN ... but could not. Please tell a way to get around the problem. thanks !

hi, The current v3.2.2 XFCE seems not stable in my laptop.Sometimes work well, but give a lot of error messages which can only be seen when shutting down; then at next boot the display resolution will not be correct (default 1024*768, instead of the NORMAL 1366*768), and cannot be adjusted; also, mo...

XFCE : give a lot of error messages during booting, then boot into "safe" mode, which the display resolution is not full sized, and mouse responses very slowly. Cinnamon : boot up nicely, without any error message; the same set of .xzm are used. scim does not function in current firefox and opera, b...

I use porteus to show .odp to students. Computer screen goes black during boot (to level 4 ? I am not sure ) and projector says 'no signal' ; this is the case for 3.2rc1 xfce; 2.1 XFCE works perfectly on the same classroom system. Unfortunately I dont know the type of projector. Please pay attention...

hi, fanthom, I did the experiment. the results: with cheatcode: >vmlinuz initrd=initrd.xz changes=/porteus acpi=off debug # grep 9: /proc/interrupts 9: 131 132 132 131 IO-APIC-fasteoi acpi with cheatcode: >vmlinuz initrd=initrd.xz changes=/porteus acpi_osi=Linux acpi_backlight=vendor debug # grep 9:...

@fanthom
Booting in Text mode ended with the same result, so I cannot get 'psinfo' report.
The same computer is running v2.1 32bit xfce without any problem.
thanks.

3.0 xfce rc1 and rc2 both, during booting this error appears : ------------- [ 15.755595] [<155046c>] ? 0xc1550460 [ 15.757073] handlers: [ 15.758550] [<c12245eb>] 0xc12245eb [ 15.760030] Disabling IRQ #9 INIT: Entering runlevel: 4 ===================================== Welcome to Porteus The system ...

XFCE, 32-bit Someone successfully boot up v3.0 rc1 with bootloader grub ? I try several times but failed. Booting stops at a line say something like "eth0..eth1.. not available". With reiserfs, the installer fallback to lilo but give error message. The new version LibreOffice cannot be launched; old...

thank you, tome, I will try.

hi, saman,
Would you like to send me a cope of your wps .xzm ? or teach me the details how to made it from .deb, or .tar.xz ?
I find wps is much better than libreO. Thanks

great ! works perfectly in Porteus2.1 32bit XFCE.thanks, wread !

hi, miguipda, Two modules are necessary to show and type zh-characters: * scim (-in repo) * a locale (I tried the locales in repo but failed. I use a locale .xzm built in v1.1 using 'language-select-tool', and it still works very well in v2.1) more if you need fonts. Put them in 'modules' and done. ...

thank you, don570 ! audacity works now.