Page 1 of 1

Boot loader broken after burning to USB

Posted: 09 Apr 2015, 04:04
by tim.wiot
After going through the wizard and burning a kiosk 3.3 image to USB this is the result I get. Have tried two different USB drives. 3.1 works fine.

Image

Re: Boot loader broken after burning to USB

Posted: 09 Apr 2015, 08:41
by fanthom
never seen such behavior before ... - was the ISO modified in any way?
whats the RAM available on this PC? could you install the same ISO on virtual hard drive in VirtualBox?

thanks

Re: Boot loader broken after burning to USB

Posted: 10 Apr 2015, 00:56
by tim.wiot
It's the stock ISO not modified in any way but it's not the installer that's the issue. Used both DD in Porteus and Win32DiskImager on Win 8 64 bit to dump the ISO to a USB. Runs fine on the machine (Dell e5400, 2GB or RAM). Will try another machine.